how to install laminate flooring

A Step-by-Step Guide on How to Install Laminate Flooring

Laminate flooring has become a popular choice for homeowners looking to enhance the aesthetic appeal of their homes without breaking the bank. Not only is laminate flooring in St. Augustine, Port Orange, Ocala, and Orange City, FL cost-effective, but it is also durable and easy to maintain. 
 

If you're considering a DIY laminate flooring project, this guide will provide you with a step-by-step approach on how to install laminate flooring in your home.
 

How to install laminate flooring yourself 

Materials needed:

Before you begin the installation process, make sure you have the following materials on hand:

  • Laminate flooring planks
  • Underlayment
  • Vapor barrier (if not included with the underlayment)
  • Tape measure
  • Pencil
  • Spacers
  • Crosscut saw or power saw
  • Tapping block
  • Hammer
  • Pull bar
  • Transition strips (if needed)
  • Rubber mallet

Step 1: prepare the subfloor

Ensure that the subfloor is clean, dry, and level. Remove any existing flooring and repair any imperfections in the subfloor. Lay down the underlayment, ensuring it covers the entire floor area. If your underlayment doesn't have a built-in vapor barrier, add a separate layer of vapor barrier to protect against moisture.
 

Step 2: acclimate the laminate floors

Allow the laminate flooring to acclimate to the room for at least 48 hours before installation. This helps prevent expansion or contraction of the planks after installation.
 

Step 3: plan the layout

Start planning the layout by determining the direction in which you want the planks to run. Typically, it's recommended to install laminate flooring parallel to the longest wall in the room. Use spacers to maintain a consistent gap between the flooring and the walls, allowing for expansion.
 

Step 4: install the first row

Begin by laying the first row of laminate planks along one wall, connecting them tongue-and-groove. Place spacers between the planks and the wall to maintain the expansion gap. Cut the last plank in the row to fit using a crosscut saw or power saw.
 

Step 5: install subsequent rows

Continue installing the subsequent rows, interlocking the tongue-and-groove edges. Stagger the seams between rows to create a more visually appealing and stable floor. Use a tapping block and rubber mallet to ensure a tight fit between the planks.
 

Step 6: cut planks to fit 

As you approach the end of a row, you'll likely need to cut planks to fit. Measure and mark the cutting line, then use a saw to make precise cuts. A pull bar can be helpful in connecting the final plank in each row.
 

Step 7: install transition strips

If your laminate flooring installation transitions to another type of flooring or a different room, install transition strips to create a seamless and finished look.
 

Visit Floor Factory Outlet for quality laminate flooring in St. Augustine, FL and beyond!

Congratulations, you've successfully installed laminate flooring in your home! Enjoy the beauty and durability of your new floor. If you encounter any challenges or are looking for high-quality laminate flooring options, consider reaching out to Floor Factory Outlet. With locations in St. Augustine, Port Orange, Ocala, and Orange City, FL, Floor Factory Outlet offers a wide selection of flooring materials and expertise to help you achieve the perfect look for your home. Contact or visit one of our locations to explore your options and turn your flooring dreams into reality.